Lexus ES: ECU Malfunction (B1003)
Lexus ES (XZ10) Service Manual / Power Source & Network / Networking / Can Communication System (for Gasoline Model) / ECU Malfunction (B1003)
DESCRIPTION
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B1003 | ECU Malfunction | A malfunction in the non-volatile storage of the central gateway ECU (network gateway ECU) is detected. | Central gateway ECU (network gateway ECU) | - |
PROCEDURE
| 1. | RECONFIRM DTC OUTPUT |
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Central Gateway / Trouble Codes.
Body Electrical > Central Gateway > Trouble Codes| Result | Proceed to |
|---|---|
| DTC B1003 is not output from the central gateway ECU (network gateway ECU) | A |
| DTC B1003 is output from the central gateway ECU (network gateway ECU) | B |
| A | .gif) | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU) |
.gif)
READ NEXT:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Diagnostic Trouble Code Chart DTC No. Detection Item Trouble Area Link B1003 ECU Malfunction Central gateway ECU (network gateway ECU)
Data List / Active Test
DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faul
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) When communication fails in any of the CAN bus lines (communication lines), a fail-safe function(s) will operate. The fail-safe function that is specified for ea
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR valve assembly removal/installation are shown below. Necessary Procedures After Parts Removed/Instal
Open in IG Circuit (B242E)
DESCRIPTION The headlight ECU sub-assembly operates using the power source voltage input from the IG terminal and ECUB terminal. The IG terminal power source voltage is supplied by turning the IG1-NO. 1 relay to ON. The headlight ECU sub-assembly receives engine switch on (IG) signals from the main
© 2016-2026 Copyright www.lexguide.net
