Lexus ES: Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Rear Camera / Trouble Codes.
Chassis > Rear Camera > Trouble Codes(e) Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
Body Electrical > Navigation System > Trouble Codes(f) Check for DTCs.
Click here .gif)
NOTICE:
The multi-display assembly outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.
| System | Proceed to |
|---|---|
| Audio and Visual System*1 | |
| Navigation System*2 | |
- *1: w/o Navigation System
- *2: w/ Navigation System
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Rear Camera / Trouble Codes.
Chassis > Rear Camera > Clear DTCs(e) Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
Body Electrical > Navigation System > Clear DTCs(f) Clear the DTCs.
READ NEXT:
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use the following procedure to troubleshoot the parking assist monitor system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT
Image from Camera for Parking Assist Monitor is Abnormal
DESCRIPTION The video signal from the rear television camera assembly is transmitted to the multi-display assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
If the cable was disconnected fro
Initialization
INITIALIZATION INITIALIZE PARKING ASSIST MONITOR SYSTEM (a) When "!" mark is displayed on the image of the area behind the vehicle, perform the following procedure to correct the steering angle neutra
SEE MORE:
Brake Hold Switch
ComponentsCOMPONENTS ILLUSTRATION *1 BRAKE HOLD SWITCH (NO. 2 COMBINATION SWITCH ASSEMBLY) *2 REAR UPPER CONSOLE PANEL SUB-ASSEMBLY InspectionINSPECTION PROCEDURE 1. INSPECT BRAKE HOLD SWITCH (NO. 2 COMBINATION SWITCH ASSEMBLY) (a) Make sure that there is no looseness in the lockin
Removal
REMOVAL PROCEDURE 1. REMOVE REAR SEAT CUSHION ASSEMBLY Click here 2. REMOVE REAR SEAT CUSHION LOCK HOOK Click here 3. REMOVE REAR DOOR SCUFF PLATE LH Click here 4. REMOVE REAR UNDER SIDE COVER LH (a) Remove the 2 clips (A). *a Clip (A) *b Clip (B) *c Clip (C)
