Lexus ES manuals

Lexus ES: Dtc Check / Clear

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Panoramic View Monitor System (for Hv Model) / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Start the engine.

(c) Turn the Techstream on.

(d) Enter the following menus: Chassis / Circumference Monitoring Camera Control Module / Trouble Codes.

(e) Check the details of the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Start the engine.

(c) Turn the Techstream on.

(d) Enter the following menus: Chassis / Circumference Monitoring Camera Control Module / Trouble Codes.

(e) According to the display on the Techstream, select the trouble code data display with the clear button.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs

READ NEXT:

 ECU Power Source Circuit

DESCRIPTION This circuit is the power source circuit to operate the parking assist ECU. The parking assist ECU controls the panoramic view monitor system. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTIC

 How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the panoramic view monitor system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT

 Image from Camera for Panoramic View Monitor is Abnormal

DESCRIPTION The display signal from each camera is transmitted to the multi-display assembly via the parking assist ECU. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When "!" is displayed on th

SEE MORE:

 Image from Camera for Parking Assist Monitor is Abnormal

DESCRIPTION The video signal from the rear television camera assembly is transmitted to the multi-display assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: If the cable was disconnected from and reconnected to the negative (-) auxiliary battery terminal, the estimated course lines may not

 Installation

INSTALLATION PROCEDURE 1. INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) (a) Install a new gasket to the front exhaust pipe assembly (TWC: Rear Catalyst). (b) Connect the front exhaust pipe assembly (TWC: Rear Catalyst) to the 2 exhaust pipe supports. (c) Install the front exhaust pipe ass

© 2016-2026 Copyright www.lexguide.net