Lexus ES manuals

Lexus ES: Does not Recognize Voice Commands Performed to Contact Support Center

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Cellular Communication / Lexus Enform System (for Hv Model) / Does not Recognize Voice Commands Performed to Contact Support Center

PROCEDURE

1.

CHECK COMMUNICATION BASED VOICE RECOGNITION FUNCTION

(a) While paying attention to the condition of the spoken voice command, say "Find a gas station in New York" and check that voice recognition is operating normally.

HINT:

  • When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon. (Example: When "Find a gas station in New York" is spoken, "Find a gas station in New York" is displayed in the voice recognition result display area.)
  • If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
  • The system cannot recognize voice commands when multiple people are speaking simultaneously.
  • If the speaking speed is too fast or too slow, the recognition rate may decrease.
  • The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).

OK:

Voice command is recognized normally.

OK

END
NG

CONTACT SERVICE CENTER

READ NEXT:

 How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the LEXUS ENFORM system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT

 Operation Check

OPERATION CHECK LEXUS APP SUITE RESET PROCEDURE (a) Duplicate the problem symptom. (b) Check for DTCs and repair the systems for which any DTCs are output. Click here (c) Check cellular phone compa

 Parts Location

PARTS LOCATION ILLUSTRATION *1 ROOF ANTENNA ASSEMBLY - GPS - Telephone Main *2 FRONT NO. 2 SPEAKER ASSEMBLY RH *3 NAVIGATION ANTENNA ASSEMBLY - Telephone Sub *4 DLC3 *5 DCM (

SEE MORE:

 Automatic High Beam

The Automatic High Beam uses an in-vehicle camera sensor to assess the brightness of streetlights, the lights of vehicle ahead, etc., and automatically turns the high beam on or off as necessary. WARNING â– Limitations of the Automatic High Beam Do not rely on the Automatic High Beam. Alwa

 Power Trunk Lid does not Operate Using Outside Switch

DESCRIPTION The door control switch signal is sent to the luggage closer motor assembly. If the power trunk lid does not operate using the door control switch, a door control switch circuit malfunction is a possible cause. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: If the luggage closer motor a

© 2016-2026 Copyright www.lexguide.net