Lexus ES: Diagnostic Trouble Code Chart
Lexus ES (XZ10) Service Manual / Power Source & Network / Networking / Can Communication System (for Hv Model) / Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Diagnostic Trouble Code Chart| DTC No. | Detection Item | Trouble Area | Link |
|---|---|---|---|
| B1003 | ECU Malfunction | Central gateway ECU (network gateway ECU) | |
.gif)
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faul
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) When communication fails in any of the CAN bus lines (communication lines), a fail-safe function(s) will operate. The fail-safe function that is specified for ea
Dtc Check / Clear
DTC CHECK / CLEAR CHECK FOR DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Central Gateway
SEE MORE:
DCM Data Signal Circuit between Navigation ECU and DCM
DESCRIPTION This circuit is used to send and receive signals between the DCM (Telematics Transceiver), radio receiver assembly and navigation ECU. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - DCM (TELEMATICS TRANSCEIVER)) (a) Disconnect the G128 DCM (T
Brake Control Warning Light Remains ON
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) is connected to the combination meter assembly via CAN communication. If the skid control ECU (brake booster with master cylinder assembly) stores a DTC, the brake warning light / yellow (minor malfunction) comes on in th
© 2016-2026 Copyright www.lexguide.net
