Lexus ES manuals

Lexus ES: Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

Active Noise Control System

DTC No.

Detection Item

Link

B1AA044

ANC ECU EEPROM Data Memory Failure

B1AA187

UART Communication Between ANC and Audio Amplifier Missing Message

B1AA296

Front Left Microphone Circuit Component Internal Failure

B1AA31C

Front Left Microphone Circuit Circuit Voltage Out of Range

B1AA696

Front Right Microphone Circuit Component Internal Failure

B1AA71C

Front Right Microphone Circuit Circuit Voltage Out of Range

B1AAA96

Rear Center Microphone Circuit Component Internal Failure

B1AAB1C

Rear Center Microphone Circuit Circuit Voltage Out of Range

P033531

Crankshaft Position Sensor "A" No Signal

U010087

Lost Communication With ECM/PCM "A" Missing Message

U012987

Lost Communication With Brake System Control Module Missing Message

U014087

Lost Communication with Body Control Module Missing Message

U016487

Lost Communication with HVAC Control Module Missing Message

READ NEXT:

 Dtc Check / Clear

DTC CHECK / CLEAR CHECK FOR DTC (CHECK USING TECHSTREAM) (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Ele

 Freeze Frame Data

FREEZE FRAME DATA CHECK FREEZE FRAME DATA HINT: Whenever an active noise control system DTC is stored, the stereo component equalizer assembly stores the current vehicle state as freeze frame data. (a

 How To Proceed With Troubleshooting

PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT 2. CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK NEXT 3. INSPECT BATTERY VOLTAGE (a) Measure th

SEE MORE:

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: If the auxiliary battery voltage is low, the mirror heater function may not operate. HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probab

 Disassembly

DISASSEMBLY CAUTION / NOTICE / HINT NOTICE: Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into th

© 2016-2026 Copyright www.lexguide.net