Lexus ES: Diagnostic Trouble Code Chart
Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Parking Assist Monitor System (for Hv Model) / Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Parking Assist Monitor System| DTC No. | Detection Item | Link |
|---|---|---|
| C1611 | ECU Malfunction | |
| C1621 | Back Camera Power Supply Failure | |
| C1622 | Back Camera Disconnected | |
| C1625 | Open or Short in Steering Angle Sensor +B | |
| C1626 | Steering Angle Sensor Failure | |
| C168D | Vehicle Information Unmatched | |
| C1691 | Back Camera Initialization Incomplete | |
| C1694 | Steering Angle Initialization Incomplete | |
| U0100 | Lost Communication with ECM / PCM "A" | |
| U0126 | Lost Communication with Steering Angle Sensor Module | |
| U0140 | Lost Communication with Body Control Module | |
| U0163 | Lost Communication with Navigation Control Module | |
| U0233 | Lost Communication with Blind Spot Monitor Master Module | |
| U1000 | CAN Communication Failure (Message Registry) | |
| U1110 | Lost Communication with Intuitive Parking Assist Module | |
.gif)
READ NEXT:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Chassis / Rear Camera / Trouble Codes.
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use the following procedure to troubleshoot the parking assist monitor system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT
Image from Camera for Parking Assist Monitor is Abnormal
DESCRIPTION The video signal from the rear television camera assembly is transmitted to the multi-display assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
If the cable was disconnected fro
SEE MORE:
Actuator Cut Circuit Stuck Off (P16B09F)
MONITOR DESCRIPTION The ECM monitors the operation of the throttle actuator. When a malfunction is detected in the throttle actuator cut circuit immediately after the power switch is turned off, the ECM illuminates the MIL and stores a DTC. DTC No. Detection Item DTC Detection Condition Tro
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 2. REMOVE ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY NOTICE:
Avoid physical shock to the accelerator pedal sensor assembly.
Do not disassemble the accelerator pedal sensor assembly.
The accelerator pedal s
© 2016-2026 Copyright www.lexguide.net
