Lexus ES manuals

Lexus ES: DCM System Internal Failure (B15A804)

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Cellular Communication / Safety Connect System (for Gasoline Model) / DCM System Internal Failure (B15A804)

DESCRIPTION

This DTC is stored when an internal circuit malfunction is detected by the DCM (telematics transceiver) self check.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B15A804

DCM System Internal Failure

DCM (telematics transceiver) internal malfunction

DCM (telematics transceiver)

CAUTION / NOTICE / HINT

NOTICE:

  • Regardless of whether DTC B15A804 has been output as a present or history DTC, the DCM (telematics transceiver) should be replaced.
  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Safety Connect System.

    Click here

PROCEDURE

1.

REPLACE DCM (TELEMATICS TRANSCEIVER)

(a) Replace the DCM (telematics transceiver) with a new one.

Click here

NOTICE:

  • The engine switch must be off.
  • Do not exchange the DCM (telematics transceiver) with one from another vehicle.
NEXT

PERFORM DCM ACTIVATION

READ NEXT:

 GNSS Antenna Circuit Short to Ground (B15C111,B15C113)

DESCRIPTION These DTCs are stored when a malfunction occurs in the telephone and GPS antenna assembly (for Roof Side) circuit. DTC No. Detection Item DTC Detection Condition Trouble Area

 Airbag Signal Signal Plausibility Failure (B15C464)

DESCRIPTION If the DCM (telematics transceiver) detects an error in communication between the DCM (telematics transceiver) and the airbag ECU assembly as a result of the DCM (telematics transceiver) s

 Emergency Call Switch Circuit Short to Ground (B15C511,B15C513)

DESCRIPTION If the DCM (telematics transceiver) detects an error in the communication between the DCM (telematics transceiver) and the map light sub-assembly (manual (SOS) switch) as a result of the D

SEE MORE:

 On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (a) for RH Side (1) Operate the windshield wiper motor assembly. (2) Stop the windshield wiper motor assembly operation. (3) Check the automatic stop (park) position. HINT: After the front wiper motor is stopped, check the

 Lost Communication with Hybrid Powertrain Control Module (Hybrid/EV Battery Local Bus) Missing Message (U115087)

DESCRIPTION The battery ECU assembly transmits and receives signals via CAN communication to and from the hybrid vehicle control ECU. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate U115087 Lost Communication with Hybrid Powertrain Control Module (

© 2016-2026 Copyright www.lexguide.net