Lexus ES: Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Road Sign Assist / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Road Sign Assist > Data List| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Total Distance Traveled | - | - | - | Cannot be used |
| Total Distance Traveled - Unit | - | - | - | Cannot be used |
| Traffic Sign Estimated Speed Unit | - | - | - | Cannot be used |
| Traffic Sign Estimated Traffic Division | - | - | - | Cannot be used |
| RSA Navigation Fusion Control | RSA navigation fusion control setting | OFF or ON | OFF: RSA navigation fusion control off ON: RSA navigation fusion control on | - |
READ NEXT:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Road Sign Assist System DTC No. Detection Item Link U010087 Lost Communication with ECM/PCM "A" Missing Message U012587 Lost Communication with Mu
Vehicle Control History
VEHICLE CONTROL HISTORY NOTICE: Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again. CHECK VEHICLE CONTROL HISTORY (ROAD SI
Lost Communication with ECM/PCM "A" Missing Message (U010087,U012587,U012987,U014087,U015587)
DESCRIPTION When a malfunction is detected between various ECUs and sensors, these DTCs are stored. DTC No. Detection Item DTC Detection Condition Trouble Area U010087 Lost Communicatio
SEE MORE:
Intake Air Control Valve(for Acis)
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT INTAKE AIR CONTROL VALVE (for ACIS) (a) Disconnect the vacuum hose sub-assembly from the intake air control valve (for ACIS). (b) Connect a hose and vacuum pump to the intake air control valve (for ACIS). (c) Using th
Inspection
INSPECTION PROCEDURE 1. INSPECT SHIFT LOCK CONTROL ECU HINT: If the results of the following inspections are as specified but a malfunction has occurred, replace the shift lock control unit assembly. (a) Inspect wire harness: (1) Disconnect the shift lock control ECU connector. (2)
