Lexus ES: Customize Parameters
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Wiper / Washer / Wiper And Washer System (for Hv Model) / Customize Parameters
CUSTOMIZE PARAMETERS
NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
HINT:
The following items can be customized.
CUSTOMIZE WIPER AND WASHER SYSTEM (w/ Auto Wiper System)
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the power switch on (IG).
(3) Turn the Techstream on.
(4) Enter the following menus: Utility / Customize / Wiper.
(5) Select the setting by referring to the table below.
Wiper| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Auto Wiper | Function to enable AUTO wiper operation | Avail | 0:Avail,1:Not Avl | Rain Sensor |
HINT:
Changes to the customize settings will not be applied until the power switch is turned off then ON.
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: Before replacing the main body ECU (multiplex network body ECU), refer to Registration. Click here HINT:
Use the table below to help determine the cause of problem
Utility
UTILITY OPERATION HISTORY HINT: History of Reason for Operation: The windshield wiper motor assembly stores Operation History which can be read using the Techstream, when a malfunction of the wiper an
Terminals Of Ecu
TERMINALS OF ECU CHECK WINDSHIELD WIPER MOTOR ASSEMBLY (a) Disconnect the A38 windshield wiper motor assembly connector. (b) Measure the voltage and resistance on the wire harness side connector acco
SEE MORE:
Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HORN RELAY *a Component without harness connected (HORN Relay) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 A
Open in Outer Mirror Indicator(Slave) (C1AB5)
DESCRIPTION This DTC is stored when the blind spot monitor sensor LH detects an open in the outer rear view mirror indicator LH. DTC No. Detection Item DTC Detection Condition Trouble Area C1AB5 Open in Outer Mirror Indicator(Slave) Both of the following conditions are met:
The b
© 2016-2026 Copyright www.lexguide.net
