Lexus ES: Cruise Control System Internal Failure (P057504,P057549)
DESCRIPTION
When the ECM detects an internal malfunction, DTC P057504 or P057549 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | DTC Output from |
|---|---|---|---|---|---|
| P057504 | Cruise Control System Internal Failure | When the dynamic radar cruise control system is operating, the ECM detects a malfunction in the internal cancel circuit for 0.4 seconds or more. | ECM | Does not come on | Engine |
| P057549 | Cruise Control Internal Electronic Failure | When the dynamic radar cruise control system is operating, the ECM detects a malfunction in the internal STP signal circuit for 0.2 seconds or more. | ECM | Does not come on | Engine |
CAUTION / NOTICE / HINT
NOTICE:
Before replacing the ECM, refer to Registration.
Click here .gif)
PROCEDURE
| 1. | CHECK FOR DTCs |
(a) Clear the DTCs.
Powertrain > Radar Cruise1 > Clear DTCs(b) Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
(c) Check for DTCs.
Powertrain > Radar Cruise1 > Trouble Codes| Result | Proceed to |
|---|---|
| DTC P057504 and P057549 are not output. | A |
| DTC P057504 or P057549 is output. | B |
| A | .gif) | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE ECM |
READ NEXT:
Brake System (P157800)
DESCRIPTION When a malfunction in the electronically controlled brake system is detected, DTC P157800 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area MIL DTC Output
Cruise Control Input Processor (P160700)
DESCRIPTION When the ECM detects that it is not functioning normally, DTC P160700 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area MIL DTC Output from P160700
Cruise Control Input Processor (P160700)
DESCRIPTION When the ECM detects that it is not functioning normally, DTC P160700 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area MIL DTC Output from P160700
SEE MORE:
GVIF Disconnected (from EMV/MM Integrated Device to Multi Display) (B1575)
DESCRIPTION The radio receiver assembly and multi-display assembly are connected via video signal (digital) lines. This DTC is stored when a video signal (digital) line is disconnected. DTC No. Detection Item DTC Detection Condition Trouble Area B1575 GVIF Disconnected (from EMV/MM In
Basic Inspection
CAUTION / NOTICE / HINT When a malfunction is not confirmed by the DTC check, troubleshooting should be carried out for all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following procedure, the location of the problem ca
