Lexus ES: Control Module Communication Bus "A" Off (U0073,U0126,U0129,U0140,U0155)
DESCRIPTION
These DTCs are stored when the clearance warning ECU assembly cannot receive and recognize several signals via the CAN communication line.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0073 | Control Module Communication Bus "A" Off | Control module communication bus off | CAN communication system |
| U0126 | Lost Communication With Steering Angle Sensor Module | Lost communication with steering sensor | CAN communication system |
| U0129 | Lost Communication with Brake System Control Module | Lost communication with skid control ECU | CAN communication system |
| U0140 | Lost Communication with Body Control Module | Lost communication with main body ECU (multiplex network body ECU) | CAN communication system |
| U0155 | Lost Communication with Instrument Panel Cluster (IPC) Control Module | Lost communication with the combination meter assembly | CAN communication system |
HINT:
When 2 or more DTCs starting with "U" are output simultaneously, inspect the connectors and wire harnesses of each ECU.
PROCEDURE
| 1. | CHECK DTC OUTPUT |
(a) Clear the DTCs
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs(b) Check for CAN communication system DTCs
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes| Result | Proceed to |
|---|---|
| CAN communication system DTCs are output | A |
| No CAN communication system DTCs are output | B |
| A |  | GO TO CAN COMMUNICATION SYSTEM |
| B | | USE SIMULATION METHOD TO CHECK |
READ NEXT:
CAN Communication Failure (Message Registry) (U1000)
DESCRIPTION If DTC U1000 is stored frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again even if the DTC is not output when rechecking for DTCs. DTC
Buzzer does not Sound
WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Inspect the fuses for circuits related to this system before per
SEE MORE:
Open in One Side of Bus 2 Branch Line
DESCRIPTION When the CAN bus main lines are normal (no open, short to ground, short to +B or short between lines) and there is an ECU or sensor on the "Communication Bus Check" screen that is indicated as not communicating or whose connection status on the "Communication Bus Check" screen changes in
Open in B Power Line (B242F)
DESCRIPTION The headlight ECU sub-assembly operates using the power source voltage input from the IG terminal and ECUB terminal. The power source voltage of the ECUB terminal is supplied when the main body ECU (multiplex network body ECU) turns the ECUB power supply relay (H-LP LH relay and H-LP RH
