Lexus ES: CD cannot be Inserted / Played or CD is Ejected Right After Insertion
CAUTION / NOTICE / HINT
NOTICE:
-
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
.gif)
-
When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio receiver assembly may not operate normally.
PROCEDURE
| 1. | CHECK IF A PROPER CD IS INSERTED |
(a) Make sure that the CD is an audio CD or a CD with an MP3, WMA or AAC file, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.
OK:
CD is normal.
HINT:
- Translucent or uniquely-shaped CDs cannot be played.
- CDs with adhesive paper labels should not be played.
- Commercial audio CDs can be played.
- CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.
- MP3, WMA and AAC files on CD-ROMs, CD-Rs and CD-RWs can be played.
- For details on playable CDs, refer to Owner's Manual.
| NG |  | END (CD IS FAULTY) |
|
| 2. | CHECK THAT CD IS INSERTED PROPERLY |
(a) Check if the CD is inserted upside down.
OK:
CD is properly inserted.
| NG | | SET CD PROPERLY |
|
| 3. | CLEAN CD AND RECHECK |
| (a) Disc cleaning (1) If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction. OK: Malfunction disappears. NOTICE: Do not use a conventional record cleaner or anti-static preservative. |
|
| OK | | END (CD WAS DIRTY) |
|
| 4. | REPLACE CD AND RECHECK |
(a) Replace the CD with a new or known good one and check that the malfunction disappears.
OK:
Malfunction disappears.
| OK | | END (CD WAS FAULTY) |
| NG | | REPLACE RADIO RECEIVER ASSEMBLY |
READ NEXT:
CD Sound Skips
CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre
Cellular Phone Inspection
PROCEDURE 1. CHECK USAGE CONDITION (a) Check that the vehicle and cellular phone meet the following conditions: NOTICE: If changing cellular phone settings, updating software, etc. is necessa
Cellular Phone Registration Failure
CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre
SEE MORE:
Driving assist systems
To keep driving safety and performance,
the following systems operate
automatically in response to
various driving situations. Be aware,
however, that these systems are
supplementary and should not be
relied upon too heavily when operating
the vehicle.
Summary of the driving assist
systems
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT GARAGE DOOR OPENER (a) Press each garage door opener ("HomeLink") switch and check that the ("HomeLink") indicator light turns on. If one or more of the garage door opener ("HomeLink") switches does not turn on the ("HomeLink") indicator light, check the
