Lexus ES: CAN Communication Failure (Message Registry) (U1000)
DESCRIPTION
When the clearance warning ECU assembly determines that the CAN communication circuit is malfunctioning during self diagnosis, DTC U1000 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U1000 | CAN Communication Failure (Message Registry) | CAN communication circuit malfunction is detected | Clearance warning ECU assembly |
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Using the Techstream, check for DTCs according to the prompts on the screen.
HINT:
After turning the power switch from off to on (IG), wait 10 seconds or more before checking for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes(b) Clear the DTCs according to the screen on the Techstream.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs(c) Recheck for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble CodesOK:
DTC U1000 is not output.
HINT:
- If DTC U1000 is not output after clearing the DTCs, an intermittent CAN communication circuit malfunction is suspected.
-
If DTC U1000 is output frequently, replace the clearance warning ECU assembly, even though the DTC was not output when rechecking for DTCs.
Click here
.gif)
| OK |  | USE SIMULATION METHOD TO CHECK |
| NG | | REPLACE CLEARANCE WARNING ECU ASSEMBLY |
READ NEXT:
Utility
UTILITY FREEZE FRAME DATA NOTICE:
Freeze frame data is stored and updated each time the brakes are operated. Only the latest 30 sets of data are stored.
Using the Techstream, make sure to save th
Vehicle Control History
VEHICLE CONTROL HISTORY Vehicle Control History HINT: Part of the control history can be confirmed using the vehicle control history. Click here
SEE MORE:
Control Module Performance Bank 2 Component Internal Failure (P060596,P060796)
MONITOR DESCRIPTION The ECM continuously monitors its internal processors (CPUs) and heated oxygen sensor transistors. This self-check ensures that the ECM is functioning properly. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P060596 Control Module
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT DRIVE SHAFT ASSEMBLY (a) Check that there is no excessive play in the radial direction of the outboard joint. (b) Check that the inboard joint slides smoothly in the thrust direction. (c) Check that there is no excessive play in the radial directi
