Lexus ES manuals

Lexus ES: Camera Position Adjustment Incomplete (C1697)

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Panoramic View Monitor System (for Gasoline Model) / Camera Position Adjustment Incomplete (C1697)

DESCRIPTION

This DTC is stored when the parking assist ECU judges that the camera initial setting has not been memorized (camera view adjustment is incomplete).

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1697

Camera Position Adjustment Incomplete

Camera initial setting has not been memorized
  • Camera view adjustment
  • Parking assist ECU

CAUTION / NOTICE / HINT

NOTICE:

  • When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here

PROCEDURE

1.

ADJUST SETTINGS (CAMERA VIEW ADJUSTMENT)

(a) Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.

(1) Refer to camera view adjustment.

Click here

NEXT

2.

CHECK FOR DTC

(a) Clear the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs

(b) Check for DTCs.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes

OK:

DTC C1697 is not output.

HINT:

  • If DTC C1697 is output, perform the camera view adjustment again.
  • If DTC C1697 is still output after performing the camera view adjustment 3 times, replace the parking assist ECU.
OK

END (CAMERA VIEW ADJUSTMENT IS DEFECTIVE)
NG

REPLACE PARKING ASSIST ECU

READ NEXT:

 Calibration

CALIBRATION ADJUST PANORAMIC VIEW MONITOR SYSTEM (a) This panoramic view monitor system can be set from the diagnostic screen of the multi-display assembly. (b) If the following operations are perform

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th

 Diagnosis System

DIAGNOSIS SYSTEM PARKING ASSIST MONITOR DIAGNOSIS SYSTEM (a) For panoramic view monitor system diagnosis, signals received by the parking assist ECU can be checked, and the panoramic view monitor syst

SEE MORE:

 Check Bus 4 Lines for Short Circuit

DESCRIPTION There may be a short circuit between the CAN main bus lines and/or CAN branch lines when the resistance between terminals 22 (CA2H) and 7 (CA2L) of the central gateway ECU (network gateway ECU) is below 54 Ω. Symptom Trouble Area Resistance between terminals 22 (CA2H) and 7 (CA

 ECU Malfunction (B1370)

DESCRIPTION This DTC is stored when the windshield wiper motor assembly detects an internal malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area Memory DTC Output from B1370 ECU Malfunction Battery voltage is 9.5 V or more A malfunction is detected f

© 2016-2026 Copyright www.lexguide.net