Lexus ES: Brake Switch "A" Circuit Open (P057113)
DESCRIPTION
When the brakes are applied by the dynamic radar cruise control system, the skid control ECU (brake booster with master cylinder assembly) operates the stop light switch assembly (stop light control relay) to illuminate the stop lights.
If the hybrid vehicle control ECU receives a signal from the skid control ECU (brake booster with master cylinder assembly) indicating a malfunction of the stop light control relay, DTC P057113 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | DTC Output from |
|---|---|---|---|---|---|
| P057113 | Brake Switch "A" Circuit Open | When the dynamic radar cruise control system is operating, the hybrid vehicle control ECU detects a signal indicating a stop light control relay malfunction from the skid control ECU (brake booster with master cylinder assembly) for approximately 1 second or more. | Electronically controlled brake system | Does not come on | Hybrid vehicle control ECU |
PROCEDURE
| 1. | GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM |
HINT:
If DTC P057113 is output by the dynamic radar cruise control system, perform troubleshooting for the electronically controlled brake system first.
Click here .gif)
| NEXT | .gif) | END |
READ NEXT:
Brake Switch "A" Signal Compare Failure (P057162)
DESCRIPTION When the brake pedal is depressed, the stop light switch assembly outputs a signal to the hybrid vehicle control ECU. The hybrid vehicle control ECU uses this signal to control cancellatio
Brake Switch "A" Signal Compare Failure (P057162)
DESCRIPTION When the brake pedal is depressed, the stop light switch assembly outputs a signal to the hybrid vehicle control ECU. The hybrid vehicle control ECU uses this signal to control cancellatio
Cruise Control System Internal Failure (P057504,P057549)
DESCRIPTION When the hybrid vehicle control ECU detects an internal malfunction, DTC P057504 or P057549 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area MIL DTC Outp
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 0 °C (32 °F) 6.3 to 7.3 Ω 2
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following system after the cable is reconnected. System Name See Procedure Lane Control System (for HV
