Lexus ES manuals

Lexus ES: Back Camera Response Malfunction (C2A6A)

DESCRIPTION

During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the rear television camera assembly. This DTC is stored when the output of the rear television camera assembly does not match the expected output.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C2A6A

Back Camera Response Malfunction

Abnormal response from the rear television camera assembly

  • Rear television camera assembly
  • Parking assist ECU

CAUTION / NOTICE / HINT

NOTICE:

  • When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here

PROCEDURE

1.

CHECK FOR DTC

(a) Clear the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs

(b) Check for DTCs.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes

OK:

DTC C2A6A is not output.

OK

USE SIMULATION METHOD TO CHECK

NG

2.

REPLACE REAR TELEVISION CAMERA ASSEMBLY

(a) Replace the rear television camera assembly with a new or normally functioning one.

Click here

NEXT

3.

CHECK FOR DTC

(a) Clear the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs

(b) Check for DTCs.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes

OK:

DTC C2A6A is not output.

OK

END (REAR TELEVISION CAMERA ASSEMBLY IS DEFECTIVE)

NG

REPLACE PARKING ASSIST ECU

READ NEXT:

 Side Camera LH Response Malfunction (C2A6B)

DESCRIPTION During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the side television camera assembly LH. This DTC is stored when the output of the s

 Side Camera RH Response Malfunction (C2A6C)

DESCRIPTION During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the side television camera assembly RH. This DTC is stored when the output of the s

 Front Camera Response Malfunction (C2A6D)

DESCRIPTION During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the front television camera assembly. This DTC is stored when the output of the fro

SEE MORE:

 Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART SFI System DTC No. Detection Item MIL Memory Note Link P001001 Camshaft Position "A" Actuator Bank 1 General Electrical Failure Comes on DTC stored SAE Code: P0010 P001100 Camshaft Position "A" - Timing Over-Advanced or System Perform

 Camshaft Position Sensor "B" Bank 1 Signal Stuck in Range (P03652A,P036531,P039031)

DESCRIPTION Refer to DTC P036511. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P03652A Camshaft Position Sensor "B" Bank 1 Signal Stuck in Range No VVT sensor (for exhaust camshaft of bank 1) signal to ECM while engine cranking (1 tr

© 2016-2026 Copyright www.lexguide.net