Lexus ES: Air Fuel Ratio Sensor (for Sensor 2)
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / A25a-fks (engine Control) / Air Fuel Ratio Sensor (for Sensor 2)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 AIR FUEL RATIO SENSOR - - N*m (kgf*cm, ft.*lbf): Specified torque * For use with SST
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air
Inspection
INSPECTION PROCEDURE 1. INSPECT AIR FUEL RATIO SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Con
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE RAIN SENSOR COVER *a Stopper Remove in this Direction (1) Remove in this Direction (2) (a) Release the stopper by pulling it out and disconnect the rain sensor as indicated by the arrows, in the order shown in the illustration. (b) Disengage the
Mass or Volume Air Flow Sensor "A" Circuit Short to Battery (P010012,P010014)
DESCRIPTION The mass air flow meter sub-assembly is a sensor that measures the intake air volume using the following built-in components:
By-pass duct (allows some of the intake air to flow past a silicon chip sensor)
Silicon chip sensor (uses a heater control bridge circuit and temperature sen
© 2016-2026 Copyright www.lexguide.net
