Lexus ES: ABS Operates Before Necessary When Braking
DESCRIPTION
Troubleshooting for when ABS operates too soon due to a noisy signal from the speed sensor, a difference in output, etc.
PROCEDURE
| 1. | PERFORM TEST MODE (SIGNAL CHECK) INSPECTION (SPEED SENSOR CIRCUIT) |
(a) Using the Techstream, perform a Test Mode (Signal Check) inspection sensor check and check that speed sensor Test Mode (Signal Check) inspection items change from incomplete to complete.
Click here .gif)
| Tester Display |
|---|
| Signal Check |
OK:
Speed sensor Test Mode (Signal Check) inspection items change from incomplete to complete.
| Result | Proceed to |
|---|---|
| OK (for Front) | A |
| OK (for Rear) | B |
| NG | C |
NOTICE:
- When cleaning the front speed sensor, make sure to clean the installation hole before installation.
- Do not use parts cleaner when cleaning the front speed sensor rotor.
HINT:
The rear speed sensor and rear speed sensor rotor are incorporated into the rear axle hub and bearing assembly.
If the rear speed sensor and rear speed sensor rotor need to be replaced, replace the rear axle hub and bearing assembly.
| A |  | CLEAN FRONT SPEED SENSOR AND FRONT SPEED SENSOR ROTOR |
| B | | REPLACE REAR AXLE HUB AND BEARING ASSEMBLY |
| C | | INSPECT AND REPAIR MALFUNCTIONING SPEED SENSOR CIRCUIT |
READ NEXT:
ABS Warning Light does not Come ON
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) is connected to the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: After replacing the
ABS Warning Light Remains ON
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) is connected to the combination meter assembly via CAN communication. If any of the following is detected, the ABS warnin
Brake Actuator Operation Sound is Loud during Initial Check
CAUTION / NOTICE / HINT NOTICE: After replacing the brake actuator assembly, perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero p
SEE MORE:
Front Sensor Communication Malfunction (C1AEC)
DESCRIPTION This DTC is stored when there is an open or short circuit in the communication line between the front sensors and the ECU, or when there is a malfunction in a front sensor. DTC No. Detection Item DTC Detection Condition Trouble Area C1AEC Front Sensor Communication Malfunc
Power Retractable Mirrors do not Operate with Power Retract Mirror Switch
DESCRIPTION The outer mirror switch assembly sends the retractable outer mirror switch signal to the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) then sends the mirror retract/return signal to each outer mirror control ECU assembly via CAN communication.
