Lexus ES: System Description
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Vehicle Proximity Notification System / Vehicle Proximity Notification System / System Description
SYSTEM DESCRIPTION
Vehicle Proximity Notification System
(a) When the vehicle is being driven quietly using the motor only, the vehicle proximity notification system outputs a warning sound from the vehicle approaching speaker assembly to inform pedestrians, cyclists etc., of the approach of the vehicle.
(b) The warning sound is output by the vehicle approaching speaker assembly at a volume level that will not be perceived as noise. Also the pitch of the sound changes in accordance with vehicle speed so that the sound reflects vehicle deceleration and acceleration.
(c) Vehicle proximity notification system operation automatically stops when the vehicle is stopped, the engine starts or the vehicle is driven at 25 km/h (16 mph) or more.
READ NEXT:
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use the following procedure to troubleshoot the vehicle proximity notification system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
Operation Check
OPERATION CHECK VEHICLE PROXIMITY NOTIFICATION SYSTEM OPERATION CHECK (a) System operation check (vehicle stopped) (1) Apply the parking brake. (2) Turn the power switch on (IG). (3) With the brake pe
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of
SEE MORE:
CD cannot be Inserted / Played or CD is Ejected Right After Insertion
CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
When replacing the radio receiver assembly, alw
Inspection
INSPECTION PROCEDURE 1. INSPECT VSC OFF SWITCH (a) Make sure that there is no looseness at the locking part and the connecting part of the connector. OK: The connector is securely connected. *a Component without harness connected (VSC OFF Switch) (b) Disconnect the VSC OF
© 2016-2026 Copyright www.lexguide.net
