Lexus ES manuals

Lexus ES: Sound Quality is Bad Only when Disc is Played (Volume is Too Low)

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Navigation / Multi Info Display / Navigation System (for Hv Model) / Sound Quality is Bad Only when Disc is Played (Volume is Too Low)

CAUTION / NOTICE / HINT

NOTICE:

  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

    Click here

  • When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
    • A communication malfunction DTC may be stored.
    • The radio receiver assembly may not operate normally.

PROCEDURE

1.

REPLACE DISC AND RECHECK

(a) Replace the disc with a new or known good one and check that the malfunction disappears.

OK:

Malfunction disappears.

OK

END
NG

2.

CHECK NOISE CONDITION

(a) Check that noise is output from the speakers when a disc is inserted and is being read.

OK:

Noise is output.

OK

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY

NG

REPLACE RADIO RECEIVER ASSEMBLY

READ NEXT:

 Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND

 Speaker Circuit

DESCRIPTION If there is a short in a speaker circuit, the stereo component amplifier assembly detects it and stops output to the speakers. Thus sound cannot be heard from the speakers even if there is

 Start Up Signal Circuit between Radio Receiver Assembly and Navigation ECU

DESCRIPTION This circuit includes the navigation ECU and radio receiver assembly. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU) (a) Disco

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL BATTERY STATE SENSOR ASSEMBLY (a) Engage the 2 claws to install the battery state sensor assembly to the battery current sensor holder. (b) Connect the battery state sensor assembly connector. (c) Install the battery state sensor assembly to the auxiliary battery an

 CAN Communication Failure (Message Registry) (U1000)

DESCRIPTION When the clearance warning ECU assembly determines that the CAN communication circuit is malfunctioning during self diagnosis, DTC U1000 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area U1000 CAN Communication Failure (Message Registry) CAN communic

© 2016-2026 Copyright www.lexguide.net