Lexus ES: Problem Symptoms Table
Lexus ES (XZ10) Service Manual / Vehicle Interior / Door / Hatch / Fuel Lid Opener System (for Gasoline Model) / Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
| Symptom | Suspected Area | Link |
|---|---|---|
| Fuel lid opener does not lock/unlock | Trunk and fuel switch assembly (fuel lid opener switch) | |
| Fuel lid lock with motor assembly | | |
| Instrument panel junction block assembly | | |
| Wire harness or connector | - |
.gif)
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following s
Parts Location
PARTS LOCATION ILLUSTRATION *1 FUEL LID OPENER SWITCH *2 DLC3 *3 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - FUEL OPN RELAY *4 COMBINATION METER ASSEMBLY *5 ECM *6 NO. 1 E
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL FORWARD RECOGNITION WITH HEATER HOOD SUB-ASSEMBLY NOTICE:
Do not touch the inner surface of the forward recognition with heater hood sub-assembly. Inner Surface of Forward Recognition with Heater Hood Sub-assembly
Do not apply force to the heating ele
Components
COMPONENTS ILLUSTRATION *1 ENGINE WIRE *2 FRONT NO. 1 ENGINE MOUNTING BRACKET LH *3 WATER INLET WITH THERMOSTAT SUB-ASSEMBLY *4 GASKET *5 WATER BY-PASS HOSE *6 WIRE HARNESS CLAMP BRACKET *7 NO. 2 ENGINE MOUNTING STAY RH - - N*m (kgf*cm, ft.*lbf): Specif
© 2016-2026 Copyright www.lexguide.net
