Lexus ES manuals

Lexus ES: Precaution

Lexus ES (XZ10) Service Manual / Brake / Brake System (other) / Brake System (for Hv Model) / Precaution

PRECAUTION

CAUTION:

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore during servicing of the brake system components, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.

NOTICE:

  • This vehicle is equipped with an SRS (Supplemental Restraint System). Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing. This may cause a serious accident. Before servicing (including inspection, replacement, removal, and installation of parts), be sure to read the precautionary notices for the Supplemental Restraint System.

    Click here

  • Care must be taken to replace each part properly as it could affect the performance of the brake system and result in a driving hazard. Replace the parts with those having the same part number or equivalent.
  • It is very important to keep parts and the area clean when repairing the brake system.
  • If the vehicle is equipped with a mobile communication system, refer to Precaution in the Introduction section.

    Click here

  • Care must be taken when using magnets as they could affect the performance of the speed sensors.
  • Make sure to disable brake control before disconnecting the brake lines.

READ NEXT:

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of pr

 Brake Vacuum Hose (for Gasoline Model)

ComponentsCOMPONENTS ILLUSTRATION *1 FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY - - Tightening torque for "Major areas involving basic vehicle performance such as moving/turnin

 Vacuum Pump (for A25a-fks)

SEE MORE:

 Reassembly

REASSEMBLY PROCEDURE 1. INSTALL NO. 5 ROCKER PANEL MOULDING PROTECTOR HINT: When installing the No. 5 rocker panel moulding protector, heat the body rocker panel moulding assembly using a heat light. Heating Temperature Item Temperature Body Rocker Panel Moulding Assembly 20 to 30°C (68

 Torque Converter And Drive Plate

InspectionINSPECTION PROCEDURE 1. INSPECT TORQUE CONVERTER ASSEMBLY (a) Inspect the one-way clutch. Press on the splines of the stator with a finger and rotate it. Check that it rotates smoothly when turned clockwise and rotates with difficulty when turned counterclockwise. Difficult

© 2016-2026 Copyright www.lexguide.net