DESCRIPTION
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0101 | Lost Communication with TCM | Communication malfunction detected between luggage closer motor assembly and ECM |
|
| U0122 | Lost Communication With Vehicle Dynamics Control Module | Communication malfunction detected between luggage closer motor assembly and brake actuator assembly (skid control ECU) |
|
| U0142 | Lost Communication With Body Control Module "B" | Communication malfunction detected between luggage closer motor assembly and main body ECU (multiplex network body ECU) |
|
| U0155 | Lost Communication With Instrument Panel Cluster (IPC) Control Module | Communication malfunction detected between luggage closer motor assembly and combination meter assembly |
|
| U0327 | Lost Communication with Vehicle Security Control Module | Communication malfunction detected between luggage closer motor assembly and certification ECU (smart key ECU assembly) |
|
| U1117 | Lost Communication with Accessory Gateway | Communication malfunction detected between luggage closer motor assembly and bus buffer ECU |
|
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Back Door / Trouble Codes.
(e) Clear the DTCs.
Body Electrical > Back Door > Clear DTCs(f) Check for DTCs.
Body Electrical > Back Door > Trouble CodesHINT:
If DTCs related to a malfunction in the CAN communication system are output, refer to "How to Proceed with Troubleshooting" for the CAN communication system.
Click here
OK:
DTC U0101, U0122, U0142, U0155, U0327 and U1117 is not output.
| OK | | USE SIMULATION METHOD TO CHECK |
| NG | | GO TO CAN COMMUNICATION SYSTEM |
Luggage Compartment Door Closer does not Operate
Power Trunk Lid does not Operate Using Any Switches
Power Trunk Lid does not Operate Using Cabin Switch
Freeze Frame Data
Steering Vibrator Component Internal Failure (C1A7496)