Lexus ES: Lost Communication with ECM / PCM "A" (U0100,U0126,U0140,U0163,U0233,U1110)
DESCRIPTION
These DTCs are stored if there is a malfunction in the CAN communication system connected to the rear television camera assembly.
HINT:
If CAN communication system DTCs are stored, they may also be stored in other systems.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM "A" | Lost Communication with ECM | CAN communication system |
| U0126 | Lost Communication with Steering Angle Sensor Module | Lost communication with steering sensor | CAN communication system |
| U0140 | Lost Communication with Body Control Module | Lost communication with main body ECU (multiplex network body ECU) | CAN communication system |
| U0163 | Lost Communication with Navigation Control Module | Lost communication with radio receiver assembly | CAN communication system |
| U0233 | Lost Communication with Blind Spot Monitor Master Module | Lost communication with blind spot monitor sensor RH | CAN communication system |
| U1110 | Lost Communication with Intuitive Parking Assist Module | Lost communication with clearance warning ECU assembly | CAN communication system |
PROCEDURE
| 1. | CHECK DTC OUTPUT |
(a) Clear the DTCs.
Chassis > Rear Camera > Clear DTCs(b) Recheck for DTCs and check that no DTCs are output.
Chassis > Rear Camera > Trouble CodesHINT:
- If CAN communication system DTCs are stored, they may also be stored in other systems.
- If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
-
If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again, even though the DTC was not output when rechecking for DTCs.
Click here
.gif)
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| No DTCs are output | B |
| A |  | GO TO CAN COMMUNICATION SYSTEM |
| B | | USE SIMULATION METHOD TO CHECK |
READ NEXT:
CAN Communication Failure (Message Registry) (U1000)
DESCRIPTION This DTC is stored when the rear television camera assembly judges that it has an internal CAN malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area U1000
Buzzer does not Sound
WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Inspect the fuses for circuits related to this system before per
SEE MORE:
Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after completing the rear wheel alignment procedure are shown below. Necessary Procedures After Procedure Performed Replaced Part or Performed Procedure
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL SPARK PLUG TUBE HINT: When using a new cylinder head sub-assembly, the spark plug tubes must be replaced. (a) Apply adhesive to a new spark plug tube as shown in the illustration. Adhesive: Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent Standard Appli
