Lexus ES: Installation
Lexus ES (XZ10) Service Manual / Vehicle Interior / Mirror (ext) / Outer Mirror Control Ecu / Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL OUTER MIRROR CONTROL ECU ASSEMBLY
(a) Install the outer mirror control ECU assembly with the 2 screws.
(b) Connect the 2 connectors.
2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Click here .gif)
3. INSTALL COURTESY LIGHT ASSEMBLY
Click here
4. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
Click here
5. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
Click here
6. INSTALL NO. 2 DOOR TRIM PAD
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL *2 OUTER MIRROR SWITCH ASSEMBLY
Removal
REMOVAL PROCEDURE 1. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL Click here 2. REMOVE OUTER MIRROR SWITCH ASSEMBLY (a) Using a screwdriver, disengag
SEE MORE:
Repair
REPAIR CAUTION / NOTICE / HINT HINT:
Use the same procedure for bank 1 and bank 2.
The following procedure is for bank 2.
PROCEDURE 1. REPAIR INTAKE VALVE SEAT NOTICE:
While repairing the intake valve seat, make sure to constantly check the valve seat width and valve seating position.
R
Switch Failure (B2342)
DESCRIPTION This DTC is stored when the sliding roof ECU (sliding roof drive gear sub-assembly) detects that the sliding roof switch (map light sub-assembly) is stuck for 30 seconds or more. DTC No. Detection Item DTC Detection Condition Trouble Area B2342 Switch Failure Sliding roo
© 2016-2026 Copyright www.lexguide.net
