Lexus ES: Installation
INSTALLATION
PROCEDURE
1. INSTALL POWER SWITCH
(a) Attach the claw to install the power switch as shown in the illustration.
.png)
.png) | Install in this Direction |
2. INSTALL SWITCH BASE
Click here .gif)
3. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Click here
4. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Click here
5. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Click here
6. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Headup Display)
Click here
7. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/ Headup Display)
Click here
8. INSTALL AIR CONDITIONING CONTROL ASSEMBLY
Click here
9. INSTALL NO. 2 INSTRUMENT CLUSTER MOULDING
Click here
10. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Click here
11. INSTALL INSTRUMENT SIDE PANEL RH
Click here
12. INSTALL FRONT DOOR OPENING TRIM COVER RH
HINT:
Use the same procedure as for the LH side.
13. INSTALL COWL SIDE TRIM BOARD RH
HINT:
Use the same procedure as for the LH side.
14. INSTALL FRONT DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
15. INSTALL LOWER INSTRUMENT PANEL
Click here
16. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
Click here
17. INSTALL NO. 1 INSTRUMENT CLUSTER MOULDING
Click here
18. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Click here
19. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
20. INSTALL INSTRUMENT SIDE PANEL LH
Click here
21. INSTALL FRONT DOOR OPENING TRIM COVER LH
Click here
22. INSTALL COWL SIDE TRIM BOARD LH
Click here
23. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FORWARD RECOGNITION CAMERA *2 FORWARD RECOGNITION WITH HEATER HOOD SUB-ASSEMBLY
SEE MORE:
Engine compartment
Components
Fuse boxes
Engine oil filler cap
Engine oil level dipstick
Brake fluid reservoir
Radiator
Electric cooling fan
Condenser
Power control unit coolant reservoir
Engine coolant reservoir
Washer fluid tank
Checking and adding the engine
oil
With the engine at op
Fail-safe Chart
FAIL-SAFE CHART HINT: If the power source voltage to the multiplex tilt and telescopic ECU returns to normal within 10 seconds during tilt or telescopic operation, the operation will be resumed. If it returns to normal after 10 seconds have elapsed, the operation restarts when a tilt or telescopic o
