Lexus ES manuals

Lexus ES: Installation

INSTALLATION

PROCEDURE

1. INSTALL FUEL SENDER GAUGE ASSEMBLY

(a) for Type A:

(1) Engage the claw to install the fuel sender gauge assembly to the fuel suction tube with pump and gauge assembly.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.

(2) Engage the 2 clamps to connect the wire harness to the fuel suction tube with pump and gauge assembly.

NOTICE:

  • Do not damage the wire harness.
  • When engaging each wire harness to the clamp, engage one wire at a time.

(3) Connect the fuel sender gauge assembly connector.

(b) for Type B:

(1) Engage the 2 claws to install the fuel sender gauge assembly to the fuel gauge bracket.

(2) Engage the 2 claws to install the fuel gauge bracket with fuel sender gauge assembly to the fuel suction tube with pump and gauge assembly.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.

(3) Engage the 2 clamps to connect the wire harness to the fuel suction tube with pump and gauge assembly.

NOTICE:

  • Do not damage the wire harness.
  • When engaging each wire harness to the clamp, engage one wire at a time.

(4) Connect the fuel sender gauge assembly connector.

2. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Click here

READ NEXT:

 Fuel System

 Precaution

PRECAUTION CAUTION: Never perform work on fuel system components near any possible ignition sources. Vaporized fuel could ignite, resulting in a serious accident. Do not perform work on fuel s

 Precaution

PRECAUTION CAUTION: Never perform work on fuel system components near any possible ignition sources. Vaporized fuel could ignite, resulting in a serious accident. Do not perform work on fuel s

SEE MORE:

 Washer Fluid Level Warning Switch Circuit

DESCRIPTION When the washer fluid level is lower than a certain level, a warning message is displayed on the combination meter assembly. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstre

 Reassembly

REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL HEADLIGHT SEAL (for TMC Made) Click here 2. INSTALL HEADLIGHT BRACKET (for TMC Made) (a) Engage the 2 guides. (b) Ins

© 2016-2026 Copyright www.lexguide.net