Lexus ES: Front Right Center Sensor (C1AE3)
DESCRIPTION
The front center ultrasonic sensor RH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front center ultrasonic sensor RH. If the front center ultrasonic sensor RH has an open circuit or other malfunction, it will not function normally.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE3 | Front Right Center Sensor | A malfunction of the front center ultrasonic sensor RH. |
|
CAUTION / NOTICE / HINT
NOTICE:
If DTCs are output after repairs, turn the power switch on (IG) and the parking support alert system on. Then clear the DTCs.
Click here .gif)
PROCEDURE
| 1. | CHECK DTC OUTPUT |
(a) Check for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes| Result | Proceed to |
|---|---|
| Only DTC C1AE3 is output | A |
| DTC C1AE3 and C1AEC are output | B |
| No DTCs are output | C |
| B | .gif) | GO TO DTC (C1AEC) |
| C | | USE SIMULATION METHOD TO CHECK |
|
.gif)
| 2. | REPLACE FRONT CENTER ULTRASONIC SENSOR RH |
(a) Replace the front center ultrasonic sensor RH with new or a known good one.
Click here
HINT:
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
|
| 3. | CHECK DTC OUTPUT |
(a) Clear the DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs(b) Check for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes| Result | Proceed to |
|---|---|
| DTC C1AE3 is output | A |
| No DTCs are output | B |
| A | | REPLACE CLEARANCE WARNING ECU ASSEMBLY |
| B | | END (FRONT RIGHT CENTER SENSOR WAS DEFECTIVE) |
READ NEXT:
Front Right Sensor Malfunction (C1AE4)
DESCRIPTION The front corner ultrasonic sensor RH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front corner ultrasonic sens
Rear Left Sensor Malfunction (C1AE6)
DESCRIPTION The rear corner ultrasonic sensor LH is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear corner ultrasonic sensor
Rear Left Center Sensor Malfunction (C1AE7)
DESCRIPTION The rear center ultrasonic sensor LH is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear center ultrasonic sensor
SEE MORE:
Vehicle Speed Sensor (B2415)
DESCRIPTION The headlight ECU sub-assembly LH receives speed signals from the skid control ECU (brake actuator assembly) via CAN communication and performs light control. for LED Type Turn Signal Light DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from B2415
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft assembly removal/installation are shown below. Necessary Procedures After Parts Remov
