Lexus ES: FR Speed Sensor Wrong Installation (X0452)
DESCRIPTION
| Code | Tester Display | Measurement Item | Trouble Area |
|---|---|---|---|
| X0452 | FR Speed Sensor Wrong Installation | History of front speed sensor RH being installed incorrectly | Front Speed Sensor RH |
PROCEDURE
| 1. | CHECK FOR DTCs (HEALTH CHECK) |
(a) Perform the Health Check using the Techstream.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
| B |  | GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
| 2. | CHECK PART NUMBER (FRONT SPEED SENSOR RH) |
(a) Check that the front speed sensor RH is installed.
OK:
Proper front speed sensor RH is installed.
NOTICE:
If it is necessary to remove components in order to check the front speed sensor RH, follow the relevant installation and removal procedures and precautions for those components.
| NG | | REPLACE FRONT SPEED SENSOR RH |
.gif)
|
| 3. | CLEAR VEHICLE CONTROL HISTORY |
(a) Using the Techstream, clear the Vehicle Control History.
Chassis > Brake > Utility| Tester Display |
|---|
| Vehicle Control History (RoB) |
|
| 4. | CHECK VEHICLE CONTROL HISTORY |
(a) Using the Techstream, check for Vehicle Control History.
Chassis > Brake > Utility| Tester Display |
|---|
| Vehicle Control History (RoB) |
| Result | Proceed to |
|---|---|
| X0452 is not output | A |
| X0452 is output | B |
| A | | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE FRONT SPEED SENSOR RH |
READ NEXT:
Freeze Frame Data
FREEZE FRAME DATA FREEZE FRAME DATA/INFORMATION (a) Using the Techstream, check the vehicle condition (ECU, sensor) when the brake system operates or a DTC is output. CHECK FREEZE FRAME DATA AND INFOR
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT 2. CUSTOMER PROBLEM ANALYSIS (a) Interview the customer and confir
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK (a) When the engine switch is turned on (IG), check that the ABS warning light, brake warning light / red (malfunctio
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. SECURE VEHICLE (a) Fully apply the parking brake and chock a wheel. CAUTION:
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move,
Precaution
PRECAUTION NOTICE FOR INITIALIZATION NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System See Procedure Lane Control System Pre-collision System Parking Support Brake System Li
