Lexus ES: Dtc Check / Clear
DTC CHECK / CLEAR
CHECK FOR DTCS
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Powertrain > Hybrid Control > Trouble Codes(e) Check the DTCs and freeze frame data, and then write them down.
(f) Check the details of the DTCs.
| Techstream Display | Description |
|---|---|
| Test Failed | Shows the malfunction judgment results during the current trip. |
| Confirmed | Shows the DTCs confirmed up to now. (The number of current trips differs for each DTC.) |
HINT:
Freeze frame data is stored for both Test Failed DTCs and Confirmed DTCs.
CHECK FREEZE FRAME DATA
(a) If a DTC is stored, select it in order to display its freeze frame data.
(b) Read the freeze frame data recorded when the DTC was stored.
CLEAR DTCS
NOTICE:
Clearing the DTCs will also clear the freeze frame data.
for NICKEL METAL HYDRIDE BATTERY:
Click here .gif)
for LITHIUM-ION BATTERY:
Click here
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
(e) Clear the DTCs and freeze frame data.
Powertrain > Hybrid Control > Clear DTCsREAD NEXT:
Diagnosis System
DIAGNOSIS SYSTEM DLC3 (Data Link Connector 3) (a) Check the DLC3. Click here AUXILIARY BATTERY VOLTAGE Standard Voltage: Switch Condition Specified Condition Power switch on (IG) 11 to 1
Dtc Check / Clear
DTC CHECK / CLEAR CHECK FOR DTCS (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Powertrain / Hybrid Control / Tro
Terminals Of Ecu
TERMINALS OF ECU *a Hybrid Vehicle Control ECU - - HINT: The standard normal voltage between each pair of hybrid vehicle control ECU terminals is shown in the table below. The appropriate
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL LEAK DETECTION PUMP SUB-ASSEMBLY HINT: Only perform this procedure when replacement of the leak detection pump sub-assembly is necessary. (a) Engage the 2 claws to install a new leak detection pump sub-assembly to the charcoal canister sub-assembly. NOTICE:
Inspection
INSPECTION PROCEDURE 1. INSPECT CAMSHAFT TIMING GEAR BOLT (a) Check the stroke of the plunger in the center of the camshaft timing gear bolt. Standard Stroke: 2.2 mm (0.0866 in.) or more HINT: When pressing the plunger, there may be a stepped feeling. This is not a malfunction. If the result is
