Lexus ES manuals

Lexus ES: Disc cannot be Ejected

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Navigation / Multi Info Display / Navigation System (for Gasoline Model) / Disc cannot be Ejected

CAUTION / NOTICE / HINT

NOTICE:

  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

    Click here

  • When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
    • A communication malfunction DTC may be stored.
    • The radio receiver assembly may not operate normally.

PROCEDURE

1.

CHECK OPERATION

(a) Press the disc eject switch of the radio receiver assembly for 5 seconds or more and check that the disc is ejected.

OK:

Disc is ejected.

NG

REPLACE RADIO RECEIVER ASSEMBLY

OK

2.

REPLACE DISC AND RECHECK

(a) Replace the disc with a new or known good one and check that the malfunction disappears.

OK:

Disc is ejected.

OK

END (DISC WAS FAULTY)
NG

REPLACE RADIO RECEIVER ASSEMBLY

READ NEXT:

 Disc cannot be Inserted or is Ejected Right After Insertion

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre

 Display does not Dim when Light Control Switch is Turned ON

DESCRIPTION When the navigation system is activated with the light control switch in the tail or head position, before AVC-LAN communication is established, the multi-display assembly dims the display

 Does not Play even after Bluetooth Audio Mode is Selected

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre

SEE MORE:

 Installation

INSTALLATION CAUTION / NOTICE / HINT CAUTION: The engine assembly with hybrid vehicle transaxle assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop. PROCEDURE 1. INSTALL AUTOMATIC TRANSMISSION CASE COVER (a) Install the autom

 Components

COMPONENTS ILLUSTRATION *1 VACUUM HOSE *2 FLOW SHUTTING VALVE (NO. 1 WATER BY-PASS HOSE) *3 WATER BY-PASS HOSE ASSEMBLY *4 STEERING GEAR HEAT INSULATOR *5 WIRE HARNESS *6 FRONT FRAME ASSEMBLY *7 TRANSMISSION BREATHER CLAMP *8 HOSE CLAMP Tightening torqu

© 2016-2026 Copyright www.lexguide.net