Lexus ES: Diagnosis System
Lexus ES (XZ10) Service Manual / Vehicle Interior / Sliding Roof / Convertible / Panoramic Moon Roof System / Diagnosis System
DIAGNOSIS SYSTEM
DESCRIPTION
(a) Panoramic moon roof system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.
CHECK DLC3
(a) Check the DLC3.
Click here .gif)
INSPECT BATTERY VOLTAGE
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
- If the voltage is below 11 V, recharge or replace the battery.
READ NEXT:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Sliding Roof or Sli
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Panoramic Moon Roof System DTC No. Detection Item Link B2341 Sensor (Motor) Failure B2342 Switch Failure B2343 Position Initialization
SEE MORE:
IG2 Signal Circuit Short to Auxiliary Battery (P253012)
DESCRIPTION The hybrid vehicle control ECU compares the IG2 signal to the IG control status signal sent from the certification ECU (smart key ECU assembly) to detect a stuck on malfunction of the IG2 signal. HINT: If DTC P253012 is stored, the power switch will turn off (READY off). DTC No. Det
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during luggage door hinge torsion bar removal/installation are shown below. Necessary Procedure After Parts Re
© 2016-2026 Copyright www.lexguide.net
