Lexus ES manuals

Lexus ES: Diagnosis System

DIAGNOSIS SYSTEM

CHECK DLC3

(a) Check the DLC3.

Click here

INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery.

READ NEXT:

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa

 Dtc Check / Clear

DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Mirror L or Mirror

 Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Power Mirror Control System (w/ Memory) DTC No. Detection Item Link U0142 Lost Communication with Main Body ECU

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL SUSPENSION TOWER DAMPER (a) Install the suspension tower damper to the front bumper extension sub-assembly LH and front bumper extension sub-assembly RH with the 4 bolts. Torque: 27.5 N·m {280 kgf·cm, 20 ft·lbf} NOTICE: Do not extend or compress the damper. 2. I

 Hybrid/EV Battery Positive Contactor Circuit Short to Ground (P0AD911)

DESCRIPTION Refer to the description for DTC P0AE411. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P0AD911 Hybrid/EV Battery Positive Contactor Circuit Short to Ground Short to ground in the SMRB circuit: Primary circuit of SMR (+

© 2016-2026 Copyright www.lexguide.net