Lexus ES manuals

Lexus ES: Data List / Active Test

DATA LIST / ACTIVE TEST

DATA LIST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Navigation System / Data List.

(e) Read the Data List according to the display on the Techstream.

Body Electrical > Navigation System > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Battery Voltage

Auxiliary battery voltage

Min.: 0 V, Max.: 24 V

11 to 15.5 V

-

Active Dimmer

Active dimmer function

ON or OFF

ON: Active dimmer function on

OFF: Active dimmer function off

-

Tail Light SW

Taillight switch

ON or OFF

ON: Light control switch in tail or head position

OFF: Light control switch off or AUTO

-

Reverse Signal

Reverse signal

ON or OFF

ON: Shift lever in R

OFF: Shift lever not in R

-

Parking Brake

Parking brake switch

ON or OFF

ON: Parking brake applied

OFF: Parking brake released

-

Ignition

Power switch

ON or OFF

ON: Power switch on (IG)

OFF: Power switch off or on (ACC)

"OFF" is displayed even though the power switch is on (ACC)

Vehicle Speed

Maximum wheel speed sensor reading

Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)

Vehicle stopped: 0 km/h (0 mph)

When driving at constant speed: No large fluctuations

HDMI Line(Blu-ray Disc Player)

-

Disconnected or Connected

Disconnected

Not available

READ NEXT:

 Data Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1.

 Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Audio and Visual System DTC No. Detection Item Link B1323 Lost Communication with Haptic Device B1324 Lost Communication with Meter B1326

 Display does not Dim when Light Control Switch is Turned ON

DESCRIPTION When the audio and visual system is activated with the light control switch in the tail or head position, before AVC-LAN communication is established, the multi-display assembly dims the d

SEE MORE:

 On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. SECURE VEHICLE (a) Fully apply the parking brake and chock a wheel. CAUTION: Make sure to apply the parking brake and chock a wheel before performing this procedure. If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move,

 Components

COMPONENTS ILLUSTRATION *1 LUGGAGE COMPARTMENT FLOOR MAT *2 SPARE WHEEL COVER TRAY ILLUSTRATION *1 REAR FLOOR FINISH PLATE *2 LUGGAGE HOLD BELT STRIKER ASSEMBLY ILLUSTRATION *A for Type A *B for Type B *1 LUGGAGE COMPARTMENT TRIM COVER LH *2 LUGGAGE COMP

© 2016-2023 Copyright www.lexguide.net