Lexus ES: Components
COMPONENTS
ILLUSTRATION
| *1 | MASS AIR FLOW METER SUB-ASSEMBLY | - | - |
READ NEXT:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY HINT: Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly. Click here (a) Read the v
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during mas
Inspection
INSPECTION PROCEDURE 1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY (a) Perform a visual check for any foreign matter on the intake air temperature sensor (thermistor) of the mass air flow meter sub-a
SEE MORE:
DC/DC Converter Voltage Sensor "A"(VL) Circuit Intermittent (P314F1F)
DTC SUMMARY MALFUNCTION DESCRIPTION This DTC is stored if the value of "VL Voltage" fluctuates excessively. The cause of this malfunction may be one of the following: Area Main Malfunction Description Hybrid vehicle transaxle assembly
Open or short circuit in the motor or generator coi
Terminals Of Ecu
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (a) Disconnect the P22 sliding roof ECU (sliding roof drive gear sub-assembly) connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness
© 2016-2026 Copyright www.lexguide.net
