Lexus ES manuals

Lexus ES: CAN Communication Failure (Message Registry) (U1000)

DESCRIPTION

This DTC is stored when the rear television camera assembly judges that it has an internal CAN malfunction.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

U1000

CAN Communication Failure (Message Registry)

Can communication failure (message registry)

Rear television camera assembly

PROCEDURE

1.

CHECK DTC OUTPUT

(a) Clear the DTCs.

Chassis > Rear Camera > Clear DTCs

(b) Recheck for DTCs and check that no DTCs are output.

Chassis > Rear Camera > Trouble Codes

HINT:

  • If the DTC is not output again when rechecking for DTCs, it may have been stored due to a temporary CAN malfunction.
  • If DTC U1000 is stored frequently but is not output when rechecking for DTCs, attempt to reproduce the conditions when the malfunction occurred.

    Click here

Result

Proceed to

DTC U1000 is output

A

DTC U1000 is not output

B

A

REPLACE REAR TELEVISION CAMERA ASSEMBLY

B

USE SIMULATION METHOD TO CHECK

READ NEXT:

 Parking Assist Monitor System (for Hv Model)

 Black Screen

DESCRIPTION The video signal from the rear television camera assembly is transmitted to the multi-display assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: If the cable was disconnected fro

 Vehicle Information Unmatched (C168D)

DESCRIPTION This DTC is stored if the rear television camera assembly judges as a result of its self check that the vehicle information received from the main body ECU (multiplex network body ECU) via

SEE MORE:

 Check Bus 3 Lines for Short Circuit

DESCRIPTION There may be a short circuit between the CAN main bus lines and/or CAN branch lines when the resistance between terminals 6 (CA3H) and 21 (CA3L) of the central gateway ECU (network gateway ECU) is below 54 Ω. Symptom Trouble Area Resistance between terminals 6 (CA3H) and 21 (CA

 Precaution

PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Lane Control System (for Gasoline Model)

© 2016-2026 Copyright www.lexguide.net