Lexus ES: Camera Position Adjustment Incomplete (C1697)
DESCRIPTION
This DTC is stored when the parking assist ECU judges that the camera initial setting has not been memorized (camera view adjustment is incomplete).
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
C1697 | Camera Position Adjustment Incomplete | Camera initial setting has not been memorized | -
Camera view adjustment
-
Parking assist ECU
|
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Click here
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
PROCEDURE
1. | ADJUST SETTINGS (CAMERA VIEW ADJUSTMENT) |
(a) Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.
(1) Refer to camera view adjustment.
Click here
NEXT | | |
(a) Clear the DTCs.
Chassis > Circumference Monitoring Camera Control Module > Clear DTCs
(b) Check for DTCs.
Chassis > Circumference Monitoring Camera Control Module > Trouble Codes
OK:
DTC C1697 is not output.
HINT:
-
If DTC C1697 is output, perform the camera view adjustment again.
-
If DTC C1697 is still output after performing the camera view adjustment 3 times, replace the parking assist ECU.
OK | | END (CAMERA VIEW ADJUSTMENT IS DEFECTIVE) |
NG | | REPLACE PARKING ASSIST ECU |
READ NEXT:
CALIBRATION ADJUST PANORAMIC VIEW MONITOR SYSTEM (a) This panoramic view monitor system can be set from the diagnostic screen of the multi-display assembly. (b) If the following operations are perform
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th
DIAGNOSIS SYSTEM PARKING ASSIST MONITOR DIAGNOSIS SYSTEM (a) For panoramic view monitor system diagnosis, signals received by the parking assist ECU can be checked, and the panoramic view monitor syst
SEE MORE:
INSTALLATION PROCEDURE 1. INSTALL CAMSHAFT TIMING GEAR BOLT (a) Make sure that the No. 1 cylinder is at TDC/compression. HINT: Check that the cutout of the camshaft timing gear assembly is at the top and align the timing mark (cutout) of the crankshaft pulley with the timing mark on the timing chain
DTC SUMMARY Refer to the DTC summary for DTC P1C7779. Click here DESCRIPTION Refer to the description for DTC P1C7779. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P1C8679 Transmission (Input) Mechanical Linkage Failure Hybrid v
© 2016-2024 Copyright www.lexguide.net
![](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAEALAAAAAABAAEAAAIBTAA7)