Lexus ES: BSM Buzzer Sound Request Signal Malfunction (C2A5C)
Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Panoramic View Monitor System (for Gasoline Model) / BSM Buzzer Sound Request Signal Malfunction (C2A5C)
DESCRIPTION
This DTC is stored when the rear television camera assembly receives an invalid communication signal from the blind spot monitor sensor RH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C2A5C | BSM Buzzer Sound Request Signal Malfunction | An invalid communication signal is received from the blind spot monitor sensor RH | Rear television camera assembly |
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click here
.gif)
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
PROCEDURE
| 1. | CHECK DTC OUTPUT |
(a) Clear the DTCs.
Chassis > Rear Camera > Clear DTCs(b) Recheck for DTCs and check that no DTCs are output.
Chassis > Rear Camera > Trouble Codes| Result | Proceed to |
|---|---|
| DTC C2A5C is output | A |
| DTC C2A5C is not output | B |
| A |  | REPLACE REAR TELEVISION CAMERA ASSEMBLY |
| B | | END |
READ NEXT:
BSM Buzzer Malfunction (C2A5D)
DESCRIPTION This DTC is stored when the rear television camera assembly receives an RCTA buzzer circuit malfunction signal from the blind spot monitor sensor RH. DTC No. Detection Item DTC Dete
Back Camera Response Malfunction (C2A6A)
DESCRIPTION During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the rear television camera assembly. This DTC is stored when the output of the rear
Side Camera LH Response Malfunction (C2A6B)
DESCRIPTION During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the side television camera assembly LH. This DTC is stored when the output of the s
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT ENGINE SWITCH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 5 (SS1) - 6 (AGND) 1 (SS2) - 6 (AGND) Not pushed 10 kΩ or higher
Tire Pressure Monitor Receiver Communication Stop (B1247)
DESCRIPTION The main body ECU (multiplex network body ECU) and tire pressure warning ECU and receiver communicate by direct line. If a malfunction occurs in this communication signal, B1247 is output by the main body ECU (multiplex network body ECU). DTC No. Detection Item DTC Detection Condi
© 2016-2026 Copyright www.lexguide.net
