Lexus ES manuals

Lexus ES: BSM Buzzer Sound Request Signal Malfunction (C2A5C)

DESCRIPTION

This DTC is stored when the rear television camera assembly receives an invalid communication signal from the blind spot monitor sensor RH.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C2A5C

BSM Buzzer Sound Request Signal Malfunction

An invalid communication signal is received from the blind spot monitor sensor RH

Rear television camera assembly

CAUTION / NOTICE / HINT

NOTICE:

  • When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here

PROCEDURE

1.

CHECK DTC OUTPUT

(a) Clear the DTCs.

Chassis > Rear Camera > Clear DTCs

(b) Recheck for DTCs and check that no DTCs are output.

Chassis > Rear Camera > Trouble Codes

Result

Proceed to

DTC C2A5C is output

A

DTC C2A5C is not output

B

A

REPLACE REAR TELEVISION CAMERA ASSEMBLY

B

END

READ NEXT:

 BSM Buzzer Malfunction (C2A5D)

DESCRIPTION This DTC is stored when the rear television camera assembly receives an RCTA buzzer circuit malfunction signal from the blind spot monitor sensor RH. DTC No. Detection Item DTC Dete

 Back Camera Response Malfunction (C2A6A)

DESCRIPTION During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the rear television camera assembly. This DTC is stored when the output of the rear

 Side Camera LH Response Malfunction (C2A6B)

DESCRIPTION During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the side television camera assembly LH. This DTC is stored when the output of the s

SEE MORE:

 Basic Inspection

DESCRIPTION When replacing the No. 1 HV supply stack sub-assembly or No. 2 HV supply stack sub-assembly, it is necessary to check, adjust and equalize the SOC of the HV battery. Otherwise, the engine may run longer than normal, resulting in a decrease in fuel efficiency. PROCEDURE 1. READ VALU

 Components

COMPONENTS ILLUSTRATION *1 FLYWHEEL HOUSING SIDE COVER *2 STARTER ASSEMBLY *3 NO. 2 ENGINE WIRE - - Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) N*m (kgf*cm, ft.*lbf): Specified torque

© 2016-2023 Copyright www.lexguide.net