Lexus ES: Back Camera Initialization Incomplete (C1691)
DESCRIPTION
This DTC is stored when the rear television camera assembly judges that the back camera initial setting has not been memorized (rear television camera assembly optical axis adjustment (back camera position setting) is incomplete).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1691 | Back Camera Initialization Incomplete | Back camera initial setting has not been memorized (rear television camera assembly optical axis adjustment (back camera position setting) is incomplete) |
|
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Click here
.gif)
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
PROCEDURE
| 1. | PERFORM SETTINGS (BACK CAMERA POSITION SETTING) |
(a) Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.
(1) Rear television camera assembly optical axis adjustment (back camera position setting).
Click here
|
.gif)
| 2. | CHECK DTC OUTPUT |
(a) Clear the DTCs.
Chassis > Rear Camera > Clear DTCs(b) Recheck for DTCs and check that no DTCs are output.
Chassis > Rear Camera > Trouble CodesHINT:
- If DTC C1691 is output, perform the rear television camera assembly optical axis adjustment (back camera position setting) again.
- If DTC C1691 is still output after performing the rear television camera assembly optical axis adjustment 3 times, replace the rear television camera assembly.
| Result | Proceed to |
|---|---|
| DTC C1691 is output | A |
| DTC C1691 is not output | B |
| A |  | REPLACE REAR TELEVISION CAMERA ASSEMBLY |
| B | | END |
READ NEXT:
Steering Angle Initialization Incomplete (C1694)
DESCRIPTION
This DTC is stored when the parking assist ECU judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).
This DTC is stored when the rear t
Camera Position Adjustment Incomplete (C1697)
DESCRIPTION This DTC is stored when the parking assist ECU judges that the camera initial setting has not been memorized (camera view adjustment is incomplete). DTC No. Detection Item DTC Detec
Calibration
CALIBRATION ADJUST PANORAMIC VIEW MONITOR SYSTEM (a) This panoramic view monitor system can be set from the diagnostic screen of the multi-display assembly. (b) If the following operations are perform
SEE MORE:
Vehicle Speed Sensor "A" No Signal (P050031)
DESCRIPTION Vehicles, which are equipped with ABS (Anti-lock Brake System), detect the vehicle speed using the skid control ECU (brake actuator assembly) and speed sensor. The speed sensor monitors the wheel rotation speed and sends a signal to the skid control ECU. The skid control ECU converts the
Inspection
INSPECTION PROCEDURE 1. INSPECT OIL PUMP RELIEF VALVE (a) Coat the oil pump relief valve with engine oil, then check that it falls smoothly into the valve hole by its own weight. HINT: If the oil pump relief valve does not fall smoothly, replace the oil pump assembly. 2. INSPECT OIL P
