Lexus ES: Sending Malfunction (Navigation to APGS) (U0073,U0100,U0129,U0140,U0155,U0164,U0198,U023B,U0265,U0293,U1110)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the CAN communication circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0073 | Sending Malfunction (Navigation to APGS) | CAN bus connection error | CAN communication system |
| U0100 | Engine ECU Communication | CAN reception error | CAN communication system |
| U0129 | VSC(ECB)ECU Communication | CAN reception error | CAN communication system |
| U0140 | Lost Communication with Body Control Module | CAN reception error | CAN communication system |
| U0155 | Meter ECU Communication | CAN reception error | CAN communication system |
| U0164 | Air Conditioner ECU Communication | CAN reception error | CAN communication system |
| U0198 | Lost Communication with Telematic Control Module | CAN reception error | CAN communication system |
| U023B | Lost Communication with Image Processing Module "B" | CAN reception error | CAN communication system |
| U0265 | Lost Communication with Image Processing Sensor A | CAN reception error | CAN communication system |
| U0293 | HV ECU Communication | CAN reception error | CAN communication system |
| U1110 | Clearance Sonar ECU Communication | CAN reception error | CAN communication system |
PROCEDURE
| 1. | CHECK DTC (CAN COMMUNICATION SYSTEM) |
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs(b) Turn the power switch off.
(c) Turn the power switch on (IG) and wait for 30 seconds.
(d) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Navigation System > Trouble CodesOK:
No DTCs are output.
| OK |  | USE SIMULATION METHOD TO CHECK |
| NG | | GO TO CAN COMMUNICATION SYSTEM |
READ NEXT:
USB Audio System Recognition/Play Error
DESCRIPTION When a USB device or "iPod" is connected to the USB jack of the No. 1 stereo jack adapter assembly, it must have playable files. The device must also communicate with and be recognized by
Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter
DESCRIPTION The stereo component amplifier assembly receives a vehicle speed signal from the combination meter assembly to control the ASL function. HINT:
A voltage of 12 V or 5 V is output from ea
Visual Mute Signal Circuit between Radio Receiver and Multi-display
DESCRIPTION The radio receiver assembly sends a visual mute signal to the multi-display assembly. As a result, a black screen is displayed when the screen changes so that noise and distorted images ar
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 COWL SIDE TRIM BOARD LH *2 FRONT DOOR OPENING TRIM COVER LH *3 FRONT DOOR SCUFF PLATE LH *4 INSTRUMENT SIDE PANEL LH *5 LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY *6 LUGGAGE DOOR OPENING SWITCH (TRUNK AND FUEL SWITCH ASSEMBLY) *7 N
Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)
DESCRIPTION If a door glass does not slide smoothly or a power window regulator motor assembly or door window regulator sub-assembly does not operate smoothly, the jam protection function may be triggered automatically, resulting in the auto up operation being unable to fully close the power window.
