Lexus ES: Rear Door Opening Trim Weatherstrip
Lexus ES (XZ10) Service Manual / Vehicle Interior / Door / Hatch / Rear Door Opening Trim Weatherstrip
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 REAR DOOR OPENING TRIM WEATHERSTRIP - -
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR DOOR OPENING TRIM WEATHERST
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT CENTER ULTRASONIC SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 4 (BI) - 6 (EI) Always 10 kΩ or higher 4 (BI) - 1 (BO) Always Below
Discharging
DISCHARGING PROCEDURE 1. DISCHARGING (WHEN USING THE LI-ION BATTERY DISCHARGER) CAUTION: Be sure to wear insulated gloves and protective goggles. NOTICE: Make sure to observe the following points when using the Li-ion battery discharger.
Set it in a secure, flat place.
Set it in a dry place pro
© 2016-2026 Copyright www.lexguide.net
