Lexus ES: RCTB Sensor (C1AF7)
DESCRIPTION
This DTC is stored when the clearance warning ECU assembly receives a signal from the blind spot monitor system via CAN communication indicating a malfunction in the blind spot monitor sensor.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AF7 | RCTB Sensor | Blind spot monitor sensor malfunction | Blind spot monitor system |
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Using the Techstream, check for DTCs according to the prompts on the screen.
HINT:
After turning the power switch from off to on (IG), wait 4 seconds or more before checking for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes(b) Clear the DTCs according to the screen on the Techstream.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs(c) Recheck for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble CodesHINT:
- DTC C1AF7 is stored when a malfunction signal sent from the blind spot monitor system is detected.
- If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1AF7 will not be output again.
- If DTC C1AF7 is output frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again, even though the DTC was not output when rechecking for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1AF7 is output | A |
| DTC C1AF7 is not output | B |
| A | .gif) | GO TO BLIND SPOT MONITOR SYSTEM |
| B | | USE SIMULATION METHOD TO CHECK |
READ NEXT:
Blind Spot Monitor Beam Axis Inspection Incomplete (C1AF9)
DESCRIPTION This DTC is stored when the clearance warning ECU assembly receives a signal from the blind spot monitor system via CAN communication indicating that the beam axis inspection is incomplete
Blind Spot Monitor Beam Axis Misalignment (C1AFA)
DESCRIPTION This DTC is stored when the clearance warning ECU assembly receives a signal from the blind spot monitor system via CAN communication indicating blind spot monitor beam axis misalignment.
Back Camera Internal Circuit (C2A63)
DESCRIPTION This DTC is stored when the clearance warning ECU assembly detects a signal indicating a malfunction in the rear television camera assembly via CAN communication. DTC No. Detection It
SEE MORE:
Pattern Select Switch Sport Mode Circuit
DESCRIPTION When selecting sport mode, the switch operation signal is sent to the hybrid vehicle control ECU. Following this, the system enters sport mode and the vehicle will be driven using sport mode. This signal is then transmitted from the hybrid vehicle control ECU via CAN to the combination m
Lost Communication with Multi-axis Acceleration Sensor Module Missing Message (U012587,U012687,U012987,U015587,U029387,U110687)
DESCRIPTION The forward recognition camera communicates with each sensor and ECU via CAN communication. If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored. DTC No. Detection Item DTC Detection Condition Trouble Area MIL DT
