Lexus ES: Blind Spot Monitor Beam Axis Inspection Incomplete (C1AF9)
DESCRIPTION
This DTC is stored when the clearance warning ECU assembly receives a signal from the blind spot monitor system via CAN communication indicating that the beam axis inspection is incomplete.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AF9 | Blind Spot Monitor Beam Axis Inspection Incomplete | The clearance warning ECU assembly receives a signal indicating that the beam axis inspection is incomplete. | Blind spot monitor system |
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Using the Techstream, check for DTCs according to the prompts on the screen.
HINT:
After turning the engine switch from off to on (IG), wait 4 seconds or more before checking for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes(b) Clear the DTCs according to the screen on the Techstream.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs(c) Recheck for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble CodesHINT:
- DTC C1AF9 is stored when a malfunction signal sent from the blind spot monitor system is detected.
- If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1AF9 will not be output again.
-
If DTC C1AF9 is output frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again, even though the DTC was not output when rechecking for DTCs.
Click here
.gif)
| Result | Proceed to |
|---|---|
| DTC C1AF9 is output | A |
| DTC C1AF9 is not output | B |
| A |  | GO TO BLIND SPOT MONITOR SYSTEM |
| B | | USE SIMULATION METHOD TO CHECK |
READ NEXT:
Blind Spot Monitor Beam Axis Misalignment (C1AFA)
DESCRIPTION This DTC is stored when the clearance warning ECU assembly receives a signal from the blind spot monitor system via CAN communication indicating blind spot monitor beam axis misalignment.
Back Camera Internal Circuit (C2A63)
DESCRIPTION This DTC is stored when the clearance warning ECU assembly detects a signal indicating a malfunction in the rear television camera assembly via CAN communication. DTC No. Detection It
Communication Error From Clearance Sonar ECU to VSC (C164B)
DESCRIPTION The electronically controlled brake system receives parking support brake system information from the clearance warning ECU assembly via CAN communication. When it is determined that there
SEE MORE:
Brake Control Warning Light does not Come ON
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) is connected to the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offse
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of
