Lexus ES: Basic Inspection
CAUTION / NOTICE / HINT
When a malfunction is not confirmed by the DTC check, troubleshooting should be carried out for all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following procedure, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential when troubleshooting the engine.
PROCEDURE
| 1. | CHECK BATTERY VOLTAGE |
NOTICE:
Carry out this check with the engine stopped and the engine switch off.
| Result | Proceed to |
|---|---|
| 11 V or higher | OK |
| Below 11 V | NG |
| NG | .gif) | CHARGE OR REPLACE BATTERY |
|
.gif)
| 2. | CHECK WHETHER ENGINE CRANKS |
| NG | | PROCEED TO PROBLEM SYMPTOMS TABLE |
|
| 3. | CHECK WHETHER ENGINE STARTS |
| NG | | GO TO STEP 6 |
|
| 4. | CHECK AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
(a) Visually check that the air cleaner filter element sub-assembly is not excessively contaminated with dirt or oil.
| NG | | REPLACE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
|
| 5. | CHECK IDLE SPEED |
(a) Check the engine idle speed.
Click here .gif)
| NG | | PROCEED TO PAGE AND CONTINUE TO TROUBLESHOOT |
|
| 6. | CHECK FUEL PRESSURE |
(a) Check the fuel pressure.
Click here
| NG | | PROCEED TO PAGE AND CONTINUE TO TROUBLESHOOT |
|
| 7. | CHECK FOR SPARK |
(a) Perform a spark test.
Click here
| OK | | PROCEED TO PROBLEM SYMPTOMS TABLE |
| NG | | PROCEED TO PAGE AND CONTINUE TO TROUBLESHOOT |
READ NEXT:
Registration
REGISTRATION CAUTION / NOTICE / HINT PROCEDURE 1. VIN (VEHICLE IDENTIFICATION NUMBER) NOTICE: The Vehicle Identification Number (VIN) must be written to a replacement ECM. HINT: The VIN is a 17-digit
Initialization
INITIALIZATION Inspection After Repair Perform Learning Value Reset and Idle Learning after replacing or servicing parts related to engine operation. Details on procedures required are indicated by an
Checking Monitor Status
CHECKING MONITOR STATUS The purpose of the monitor result (mode 06) is to allow access to the results of on-board diagnostic monitoring tests of specific components/systems that are not continuously m
SEE MORE:
Visual Mute Signal Circuit between Radio Receiver and Multi-display
DESCRIPTION The radio receiver assembly sends a visual mute signal to the multi-display assembly. As a result, a black screen is displayed when the screen changes so that noise and distorted images are not displayed. When an open exists in the circuit, noise and distorted images will be displayed in
Short circuit in Power source circuit (C13A1)
DESCRIPTION C13A1 is stored if the power supply relay in the parking brake ECU assembly has a short circuit. C13A1 is stored if the power switch is off and a voltage of 2.5 V or higher is applied to the IG terminal and an electric parking brake switch assembly malfunction or wire harness malfunction
