MONITOR DESCRIPTION
The main CPU and sub CPU of the ECM perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below are detected, this DTC is stored.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
---|---|---|---|---|---|---|
P060A47 | Internal Control Module Monitoring Processor Performance Watchdog/Safety MCU Failure | A CPU reset is performed after one of the following conditions is met (1 trip detection logic):
| ECM | Comes on | DTC stored | SAE Code: P060A |
MONITOR STRATEGY
Related DTCs | P060A: Internal control module monitoring processor performance |
Required Sensors/Components (Main) | ECM |
Required Sensors/Components (Related) | - |
Frequency of Operation | Continuous |
Duration | - |
MIL Operation | Immediate |
Sequence of Operation | None |
TYPICAL ENABLING CONDITIONS
Monitor runs whenever the following DTCs are not stored | None |
TYPICAL MALFUNCTION THRESHOLDS
Either of the following conditions is met | 1 or 2 |
1. All of the following conditions are met | - |
CPU reset | 1 time or more |
Learned throttle position - Learned accelerator pedal position | 0.4 V or higher |
Electronic throttle actuator | Off |
2. CPU reset | 2 times or more |
CONFIRMATION DRIVING PATTERN
HINT:
Click here
Click here
HINT:
Techstream Display | Description |
---|---|
NORMAL |
|
ABNORMAL |
|
INCOMPLETE |
|
HINT:
The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.
CAUTION / NOTICE / HINT
NOTICE:
After turning engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click here
HINT:
Read freeze frame data using the Techstream. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
PROCEDURE
1. | CLEAR DTC |
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Clear the DTC.
Powertrain > Engine > Clear DTCs(e) Turn the engine switch off.
|
2. | READ OUTPUT DTC (DTC P060A47) |
(a) Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
(b) Connect the cable to the battery negative (-) battery terminal.
(c) Connect the Techstream to the DLC3.
(d) Turn the engine switch on (IG).
(e) Turn the Techstream on.
(f) Wait 16 seconds or more.
(g) Enter the following menus: Powertrain / Engine / Trouble Codes.
(h) Read the DTCs.
Powertrain > Engine > Trouble Codes Result | Proceed to |
---|---|
DTCs are not output | A |
DTC P060A47 is output | B |
A | CHECK FOR INTERMITTENT PROBLEMS |
B | REPLACE ECM |